X-900 MOLD SPRAY
Wirtz announces a new mold spray product, X-900. This mold spray is only available in a liquid and is packaged in 1-gallon containers. It is in liquid form to eliminate mixing variables, such as hard or soft water and individual personal mixing variations. This new mold insulation product is made to an exact formula and will always be the same. The 1-gallon container is for ease of use, storage, and easy mixing. Your casting machine operator will find the container easy to use and very easy to mix. Each spray gun of mold spray will be the same. The operator only needs to shake the container and can see when mixing is complete.
The new Wirtz mold spray should last for 4 - 6 hours. This means only 2 mold sprays per 8-hour shift. Production increases up to 15% will be experienced for the casting shift. Cork usage will be cut in half. Dirty mixing areas will be eliminated along with the wasted casting labor used to mix the cork. No more bad mixes dumped down the drain.
Mold spray directions:
1. Mix thoroughly. Shake container until no residue remains on bottom of container.
2. Pour liquid mixture through strainer directly into spray gun.
3. Spray mold normally. Alter amount of spray to hit weight specifications as required.
4. Eject first few castings in manual mode until machine will run in automatic.
5. After casting several hours apply extra mold spray in gate area for extra running time.
6. Wire brush or use water brush to remove mold spray when reapplication is required.
|
