Search
Close this search box.

Wirtz – OxMaster Paste Mixers – OxMaster 1200 KG Mixer

Wirtz – OxMaster Paste Mixers – OxMaster 1200 KG Mixer

The OxMaster Paste Mixing System is a 1,300 KG lead paste mixing system that gives guaranteed high capacity, efficiency, and provides an environmentally safe working place for operators.

OxMaster’s mixers were the first designed specifically for the battery industry. Our mixers have been installed for over 30 years and many are still in service. OxMaster’s design starts with a single piece tub weldment and a crosshead design that provides its users with low maintenance, long term corrosion resistance, and high shear mixing. From this basis, numerous improvements in mechanical durability, electrical and controls features, and process capabilities have been made. OxMaster’s experience and design flexibility make it the most reliable and economical mixer available today.

The mixing tub is a unique pan type / high shear system that uses a cross-head design that ensures the mixing blades strike a fresh paste surface at 120 times per minute. Batch sizes can range from 550 Kg (1,200 lbs) to 1200 Kg (2,645 lbs) of dry oxide per batch with typical cycle times ranging between 10 and 25 minutes depending on chemistry, climate, mixing process, and cooling features.

Mixer configurations can be tailored for high automation or batch to batch consistency based on the variety of features that we offer as options. Our systems feature no compromises in structural and stainless steel construction. They are strong and reliable with the lowest maintenance and longest life of any mixer today. Once you decide upon an OxMaster mixer you can plan to use if for a lifetime.

Highest Quality Paste

Paste by measurement is defined by cube weights and penetration readings. Paste made by an OxMaster mixer is characterized by the start of the crystalline formation in the paste known as the “crunch” you feel when you take a handful of prepared paste and squeeze it in your hands. Acid addition, sulfation and not over mixing are the keys to the best paste.

PRODUCTION / CAPACITY:
Production speeds of up to 1,300 KG of paste in 13 minute batch cycles. Typical with cooling is 15 to 17 minutes. Dependent on the type of chemistry (Tetrabasic or Tribasic) to be achieved.

*These are very general specification and will change based on the exact configuration of the system that is ordered.

Electrical: Electrical: (Supply 480VAC, 3 phase , 60 Hz standard)   200V to 575V, 50 Hz or 60 Hz,   Control Voltage:   24VDC Main Electrical Panel:   250 Amps

Compressed Air:   Nominal air requirement of 5.5 bar (80psi), 1/2” NPT connection.

Ventilation – Exhaust: The mixer requires connection to a ventilation system with mini- mum of 3,000 CFM at 6 inches water column at the mixer. Recommended Ranges Airflow: 3000 to 3,400 cfm Static Pressure: 6 to 8.0” water column

Process Water : Water Jacket: 5 PSI, 10-gallons/minute-flow rate, 1” NPT connection. CHILLED WATER RECOMMENDED.